Whamhammer wrote:
Thompson Gearbox (V6) disassembly:
https://m.youtube.com/watch?v=tn3eJW_vygUThat’ll help you figure how to get the spring in, although, I think a M90 spring will get you below 300 fps with .20g. A M100 should place the fps around 326. Is there a reason why you are replacing the spring?
While you are in the gearbox, polish the bejeezus out of the cylinder, and make sure that there is a good amount of grease on the oring for the cylinder head and the piston head.
That AR15 scope mount definitely is sitting way high, when I disassemble my Pulse Rifle to do
Work on the hop up bucking and the stock, I will have to get you some pics of my set up; its nice and flush, with minimal extraneous work, and doesnt move around at all. I dont have an exact timeline on that.
Yeah, you kinda got in a bit of a pickle there with the sensor, if you still are having issues when I take my PR apart for work, I will take a snapshot of the wiring. You could test the red and black wires connected to either sensor end and wave a screw driver or something between the two and see if it registers on the counter.
Here is the ammo counter kit, minus the sensor.
https://airsoftgogo.com/en/product/prod ... -rifle-aegThanks for the link.
I sent the tech an M110 Nuprol spring and he said it was chron'ing at 370, and our local area is like 350 at 0.20g.
I bought a bunch on M100 and M90 springs, got this £20 M90 one which looks good so I'm gonna install that and get own chrono unit soon.
Quote:
While you are in the gearbox, polish the bejeezus out of the cylinder, and make sure that there is a good amount of grease on the oring for the cylinder head and the piston head.
Any pics or exactly what you mean here? when I had the tech install then new hopup stuff and motor I asked him oil it up and everything and he said it was fine.
Quote:
I sent the tech an M110 Nuprol spring and he said it was chron'ing at 370, and our local area is like 350 at 0.20g.
VFC AEG Spring M90 x 1, PDI AEG 100% (M90) Silicon Chrome Steel Spring Variable Pitch x 1
That's the one I plan to put in it. I got about 3 differnent (Nuprol, SHS etc) M90's and M100's but this PDI ones seems really good, and if it was chroning 370 with 20's with a Nuprol 110 I figure this will get me within 340-350.
My extented 480 cap mag arrived today - thing is huge, is definitely going to be the starting mag becuase none of my holsters will hold it and then it'll go in the dump bag. I really would like some way to reload faster, are there no 3d printing places that have the parts you can just buy? Also given the whole casing of the gun splits into two, how do you affix them to the gun? just attach to one side of the shell?
Thanks again