| The Aliens Legacy http://forum.alienslegacy.com/ |
|
| Cutts Compensator for Airsoft Thompson http://forum.alienslegacy.com/viewtopic.php?f=4&t=19762 |
Page 1 of 1 |
| Author: | ilovethecorps [ Fri May 20, 2022 9:44 am ] |
| Post subject: | Cutts Compensator for Airsoft Thompson |
All Has anyone got one of these spare? I realise that they are for M1928 models with finned barrels and which take drums and we’re not fitted on the M1A1 variant… that being said an airsoft company was manufacturing them and I saw a lot of eye watering OY bad pictures of people retro fitting them onto M1A1s… Anyway I need one for another project… if anyone has one spare… Regards Pete |
|
| Author: | septic [ Fri May 20, 2022 10:41 pm ] |
| Post subject: | |
I *might* have a spare, let me check. NB: I'm at the bottom of the world, so postage may well suck... |
|
| Author: | ilovethecorps [ Fri May 20, 2022 11:01 pm ] |
| Post subject: | |
Postage sucking might be fine |
|
| Author: | ilovethecorps [ Fri May 20, 2022 11:03 pm ] |
| Post subject: | Re: Cutts Compensator for Airsoft Thompson |
(So long as it’s properly scaled) |
|
| Author: | Whamhammer [ Thu Aug 25, 2022 10:43 pm ] |
| Post subject: | |
I am pretty sure that there are some of the 3D printing websites that offer them. |
|
| Author: | ilovethecorps [ Thu Aug 25, 2022 11:57 pm ] |
| Post subject: | |
This is now sorted… I have an original but thank you. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|