The Aliens Legacy
http://forum.alienslegacy.com/

Snow Wolf PR Disassembly
http://forum.alienslegacy.com/viewtopic.php?f=4&t=13539		 Page 1 of 1
Author:  Corp_Hicks [ Sat Aug 17, 2013 4:52 pm ]
Post subject:  Snow Wolf PR Disassembly
So I brought a 2 tone PR and I've got my hands on some OD shrouds. However, I'm struggling to get the blue shrouds off. It's a nightmare at the stock end. Should I be taking the sliding stock off before trying to get the shrouds off?
Author:  nocternus [ Sat Aug 17, 2013 4:55 pm ]
Post subject: 
Try this site from our very own PVB it shows how the shrouds are attached etc

http://www.medwaypvb.pwp.blueyonder.co.uk/pulse1.html
Author:  PVB [ Sat Aug 17, 2013 5:11 pm ]
Post subject:  Re: Snow Wolf PR Disassembly
Dunno if it's exactly the same as a Snow Wolf, but they may have glued some of it.

I did that to mine to stop it squeaking when holding the shroud by the handle.

BTW, you bought it. :wink:
Author:  Corp_Hicks [ Sat Aug 17, 2013 5:29 pm ]
Post subject: 
Hmmm. So hold it over a bowl of boiling water, just in case?

And thank you. :)
Author:  soapy [ Sat Aug 17, 2013 6:45 pm ]
Post subject: 
There's aload of glued in pins at the back just a case of priseing it open with a metel ruler or a scraper
Author:  robiwon [ Sun Aug 18, 2013 1:38 am ]
Post subject:  Re: Snow Wolf PR Disassembly
Taking apart a SW PR for the first time can be a pain. Yes, the roll pins near the rear of the shroud are the hardest to separate. Use a butter knife or similar to gently pry up around the housing and eventually they will separate. When it comes time to reassemble the gun LEAVE THE PINS OUT!!
Author:  provadan [ Thu Aug 29, 2013 3:31 am ]
Post subject:  Re: Snow Wolf PR Disassembly
Just a note..I could not pull my roll pins out, no matter how hard I tried. So I drilled the receivers out a little and the pins slip in and out without catching.
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/