So I brought a 2 tone PR and I've got my hands on some OD shrouds. However, I'm struggling to get the blue shrouds off. It's a nightmare at the stock end. Should I be taking the sliding stock off before trying to get the shrouds off?

_________________

Alien vs Predator Galaxy on Facebook - All Your Alien & Predator Needs on your Facebook wall!

Try this site from our very own PVB it shows how the shrouds are attached etc

http://www.medwaypvb.pwp.blueyonder.co.uk/pulse1.html

_________________
SSgt Kris "Bloodsucker" Kobus, VAS.
A09/TQ2.0.12136E1

Dunno if it's exactly the same as a Snow Wolf, but they may have glued some of it.

I did that to mine to stop it squeaking when holding the shroud by the handle.

BTW, you bought it.

_________________
Steve
Corporal in 69th Regt. 1st Batt. Homer’s Heroes.

"I'd like to die at the age of 80 in my own bed, with a belly full of wine and a girl's mouth around my c**k."

Hmmm. So hold it over a bowl of boiling water, just in case?

And thank you.

_________________

Alien vs Predator Galaxy on Facebook - All Your Alien & Predator Needs on your Facebook wall!

There's aload of glued in pins at the back just a case of priseing it open with a metel ruler or a scraper

Taking apart a SW PR for the first time can be a pain. Yes, the roll pins near the rear of the shroud are the hardest to separate. Use a butter knife or similar to gently pry up around the housing and eventually they will separate. When it comes time to reassemble the gun LEAVE THE PINS OUT!!

_________________
viewtopic.php?f=4&t=12784
viewtopic.php?f=4&t=12917

Just a note..I could not pull my roll pins out, no matter how hard I tried. So I drilled the receivers out a little and the pins slip in and out without catching.