| The Aliens Legacy http://forum.alienslegacy.com/ |
|
| Further Questions - Snow Wolf http://forum.alienslegacy.com/viewtopic.php?f=4&t=13178 |
Page 1 of 1 |
| Author: | ilovethecorps [ Fri Jun 07, 2013 8:47 pm ] |
| Post subject: | Further Questions - Snow Wolf |
Dear All... Just pondering the basis for a PR build... A Snow Wolf... With metal shrouds? HCG ones? And how simple would it be to install an air soft shotgun with a real SPAS cage and pump handle? Any recommendations for the best combos for a fully functional hero air soft PR? Regards, Pete |
|
| Author: | robiwon [ Sat Jun 08, 2013 12:37 am ] |
| Post subject: | Re: Further Questions - Snow Wolf |
It can and has been done. However, what you propose is not going to be cheap. If you want to do aluminum shrouds don't bother buying a Snow Wolf. All you would be using would be the Thompson. You can pick one of those up from Cyma on ebay for $100. The HCG shrouds will set you back a few hundred at least. You might as well go for the HCG GL or real steel. Again several hundred for the real steel, about $50 for the HCG GL. To be accurate you would want the Marushin m870. That is not cheap and again will cost several hundred alone. Be prepared to spend a lot of time searching, cutting, fabricating and fitting. I don't want to dissuade you, but it is a daunting task. Good luck and let us know what route you go. |
|
| Author: | Noble [ Sat Jun 08, 2013 12:55 am ] |
| Post subject: | Re: Further Questions - Snow Wolf |
maruzen and tanaka 870 shottys have been used. Marui is coming out with a new 870 soon. And a low cost Tanaka clone 870 is rumored to be released. Newer lithium poly batteries make hiding the battery source easier. |
|
| Author: | robiwon [ Sat Jun 08, 2013 1:11 am ] |
| Post subject: | Re: Further Questions - Snow Wolf |
Noble, do you know if the ejection port opens on any of the upcoming models? |
|
| Author: | ilovethecorps [ Sat Jun 08, 2013 8:28 am ] |
| Post subject: | |
I might go for a snow wolf as a stop gap and work my way towards the full all singing all dancing malarkey... Although my access to kit for a full build and build skills might be limited... If I'm honest. |
|
| Author: | robiwon [ Sat Jun 08, 2013 11:58 am ] |
| Post subject: | Re: Further Questions - Snow Wolf |
Are you wanting to keep your PR airsoft? While the one I just finished does not have any real steel parts I consider it a Hero with the lights and sound package I added. |
|
| Author: | ilovethecorps [ Sat Jun 08, 2013 7:20 pm ] |
| Post subject: | |
I probably would keep it airsoft... Though I note some people have gone the lights/sound route... |
|
| Author: | LeMay53 [ Tue Jun 18, 2013 3:13 am ] |
| Post subject: | |
I'm thinking about just using a g&p 870 in my matrix, id have to actually get it though, as well as put a real steal cage and pump onto it |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|