It can and has been done. However, what you propose is not going to be cheap. If you want to do aluminum shrouds don't bother buying a Snow Wolf. All you would be using would be the Thompson. You can pick one of those up from Cyma on ebay for $100. The HCG shrouds will set you back a few hundred at least. You might as well go for the HCG GL or real steel. Again several hundred for the real steel, about $50 for the HCG GL. To be accurate you would want the Marushin m870. That is not cheap and again will cost several hundred alone. Be prepared to spend a lot of time searching, cutting, fabricating and fitting. I don't want to dissuade you, but it is a daunting task.
Good luck and let us know what route you go.
|