Here’s a little update

I noticed in my package that I had two right thighs…


Right and left rear thighs



Right and left tibias (we see here the diminished quality between the two sides)



Right and left calves



So, I saw that I have the double of the same side of a front thigh, therefore I had to make a left side based on what I had. So, I made a clay sculpture of the left thigh.







Preparations for molding (with a wall to contain the plaster)



A small layer of releaser.



The plaster negative.



After applying my first layer of latex, here is the 2nd coat with some cheese cloth to give it more rigidity.

The latex I used is RD-407; the colour is grey because I added black Creatx paint to it.



Here is the result of the casting of the left thigh.



Right.



Left.



From eBay, I bought a $60 motorcycle dorsal protector which I will wear below the spandex, to which I will affix plastic tubes to retain the four pipes in the back, the upper ones as well as the tail. So, it looks like this:

I tried loads of bike back protectors - all the ones that were long enough to be useful to mount the tail to didn't really fit me ... that one looks good though!

That's one of Halo1's kits from Singapore, right? Never seen a build of one of those before. Thanks for the photos - great work.

Cool - I might investigate back protectors again!

You can see photos from Halo_1's sculpt/build in this old thread: viewtopic.php?f=3&t=2454

One of these days I'll be visiting Singapore again and need to see about getting one of these kits.