The Aliens Legacy
http://forum.alienslegacy.com/

PR GL Measurements Needed
http://forum.alienslegacy.com/viewtopic.php?f=3&t=4347		 Page 1 of 1
Author:  LDR [ Mon Jun 16, 2008 3:21 pm ]
Post subject:  PR GL Measurements Needed
Can anyone who used a real SPAS cage on their PR give me some measurement please? I have started cutting up my cage, but need a few specs for the ejection port. Hope some kind member here can help!

Right the measurements...:

1. From far left of SPAS cage to centre of left circle which makes up end of left side of ejection port.
2. From top of SPAS cage to centre of left cirlce which makes up end of left side of ejection port.
3. Diameter or radius of the circle which makes up end of left side of ejection port.

Basically i am trying to get the centre of the circle of the ejection port so i know where exactly to drill the holes for each end of the ejection port. Hope all that makes sense!

I have attached a picture for reference.

Thanks in advance.


Lewis

Attachments:
SPAS12_RightCut.jpg
SPAS12_RightCut.jpg [ 55.95 KiB | Viewed 1349 times ]
Author:  PVB [ Mon Jun 16, 2008 4:16 pm ]
Post subject: 
Couldn't you just work it out by looking at the end of the existing slot, just top-left of the red circle in your image?

I doubt you'd be able to drill the cage without seriously denting/pushing in the side, as it's fairly thin metal.

I think the best option (that most have used) is shown here:

http://forum.alienslegacy.com/viewtopic.php?t=2156
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/