Armor, check.

2PAT BDUs, check.

Shoulder lamp, check.

Pulse Rifle, negative.

I'm at a complete stopping point, guys. After WEEKS of trying to figue out where to start, what to do, etc. I still have NO idea what I'm doing. I can't figure out how to attach the grenade launcher. I'm three days away from making my first official combat drop at a local con and I haven't done jack s**t. I need help, guys.

I'm at the point of desparation and frustration. I got so frustrated, I actually put a screwdriver through my workbench.

_________________

Whatcha got done so far?
Pics?

_________________
MSgt, UKCM 42nd Reg., 1st Batt. : Hadrian's Wall. UKCM

Wasteland Workshop
Props, cosplay pieces, upcycled ornamentation, and miscellanea;
For the discerning survivor of the apocalypse.
Steve Fletcher : Maker, Scavenger, and Junksmith.
linktr.ee/wastelandworkshop

Umm... hand it back over to Matt or myself. But,... whatever you're gonna do, you'd better do it fast!!!

_________________
Tom

I wish I had the time to mail it back.

I drop in three days (24 August 2007 - 26 August 2007). If I can just figure out how to get the GL attached, everything else will be smooth sailin'.

Here's the grenade launcher. This section screws into the receiver... or at least it's supposed to.


Here's where I'm pretty sure I've gotta drill.

_________________

That's one of my older GL's I believe. There are holes on the under side of the GL to allow a screwdriver passage.

You need 1/2 inch spacers which should have been in there originally, between the GL and the receiver block.

Assuming the barrel vent is still attached you need to slide the unit onto the barrel and mark the holes for the screws. pre drill them being careful not to over drill which will cause the screws to wobble out and strip.

I'm assuming the barrel mag tube and barrel block have been pulled out?

PM me if you need me to call you on the telephone....too bad we don't have video conferencing.

M

You can say that again, brother. It's exactly what we need here.

Those half inch spacers are around somewhere. If I can't find 'em, though, should I make some and if so, what would you suggest using?

- EDIT -

Okay, I've found the spacers. PM sent, Matt.

_________________

If you guys have Webcams and MSn, you CAN do video conferencing.

Russ

_________________
"A writer needs a pen, a painter a brush, and a filmmaker an army." - Orson Wells.

http://www.rookscastle.com
http://www.alchemyarms.com

Well, guys, I got a call from Matsuo and he saved the day. My PR is, now, back to normal and everything is lookin' good.

Now all I gotta do is prep the armor for my shoulder lamp and I'll be ready for my first official combat drop.

_________________

Ooh-rah !