The Aliens Legacy
http://forum.alienslegacy.com/

Smartgunners headset sight - the mystery T connector
http://forum.alienslegacy.com/viewtopic.php?f=3&t=19960
Page 1 of 1

Author:  septic [ Mon Mar 20, 2023 2:35 am ]
Post subject:  Smartgunners headset sight - the mystery T connector

[also posted in the M56 Smartgun Builders Group on FB]

Based on new info from Doug, I’ve been doing some investigation on what the possible component parts of the Smartgunners sight black “T-connector” might be …
I have the original Megatron toy sight piece, as well as the excellent Mars Attacks replica, so have been using that as a starting point for sizing.

Measuring the Megatron part (circled in red) – OD 13.9mm / ID 10.5-11.5mm (bit hard to be more precise as there’s a wee bit of flex in the part).
Attachment:
Megatron part 01.jpg
Megatron part 01.jpg [ 95.5 KiB | Viewed 688 times ]


From Harry's pic, this white connecting piece is I think, 11mm OD PVC pipe [this typically has an ID of 9mm].
Attachment:
Tee and cable 01.jpg
Tee and cable 01.jpg [ 50.99 KiB | Viewed 688 times ]



Given the T-connector looks to have a diameter bigger than the ID of the Megatron part, but less than the OD, I’d estimate it’s diameter to be between 12-13mm approx... this works with Mars' replica sight part.

Searching for possible EMA parts, the 12.7mm Tee and the 12.7mm Tube Cap look to be very good candidates for most of what this part may have been made from.

My thinking so far, is that the bits of the connector in the yellow diamond are EMA parts, the red square section is fabricated from something else, and the green diamond (which I always thought was a resin part), is actually just the cable boot / protector part of an old telephone cord, or similar.
Attachment:
Parts isolated - colour coded.jpg
Parts isolated - colour coded.jpg [ 98.89 KiB | Viewed 688 times ]




Parts found here -
12.7mm Tee piece
12.7mm Tube Cap


Anyone want to place an order with EMA to test my theory ??? :)

Author:  stimpy [ Thu Mar 23, 2023 2:15 pm ]
Post subject: 

The green diamond is from the Olympus t28 flash.

Author:  septic [ Thu Mar 23, 2023 10:21 pm ]
Post subject: 

Aaaah, of course! Thank you for that! I might edit my 1st post to reflect this, for clarity.

Here's a pic of my T-connectors. Top is via Mars Attacks headset, middle is a 3d print, and the bottom is the boot from my real Olympus t28 (seen on RHS. Megatron part on LHS, for completeness).
Attachment:
Olympus t28 flash boot.jpg
Olympus t28 flash boot.jpg [ 699.55 KiB | Viewed 632 times ]

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/