Dropshipbob wrote:
You could get one printed on vinyl and have it glued to a piece of aluminum board and the whole thing cut out with a jig-saw.
The long term plan will be to use the silhouette of at least one Xenomorph, egg, egg w/ facehugger, and chestburster for the shooting booth. The silhouette will be projected onto a sheet of thin paneling or particle board and traced. It would be cut out with a jigsaw, divided in the middle horizontally, covered with a felt material that darts can stick to, and hinged so it can be stored/transported.
Again the cardboard would just be a temporary at a few cons to go with the background. I want to do this as low cost as I can while keeping the quality high, yes I know this an oxymoron.
Thanks!
Greg