Hey folks,
I was lucky enough to recently acquire one of Chef's kits and thought I would share the build pics etc with you.

The kit is 3D printed and does require some clean up and finishing as you would/should expect.

this what you get in the kit



First thing is to clean up this bit to install the switch and leds



then prepare wiring



Put the small switch in place then run the wires like this



You should end up with something like this (used hot glue to secure top )



When the little button is pressed ...



Then glue the detail piece in place



and then the little block in line with the channel



Now you can glue/drop in the perspex window sight reticule



now to prepare the catch



Assemble like this



Then glue onto the back like this



then you can glue the front comb piece on and install the elastic band



when retracted it looks like this



And then press the catch and extends like this ...



It was an easy build and looks the goods for finishing off your bucket
Cheers,

_________________
Check out my Nerf Pulse Rifle build @ http://forum.alienslegacy.com/viewtopic.php?f=3&t=13913

Nice tutorial and solid build. Thanks mate.

Regards
T
A
Z

I'd like to get my hands on one of these. What kind/size batteries does it take?

_________________
"Awww, someone tell me that's a boot!

It's a boot!"

III drops

depends on what LED setup you are going to use ... I wired them in series and hooked them to a 3.7v lipo battery via a small resistor (reducing voltage to around 1.5v under load)

_________________
Check out my Nerf Pulse Rifle build @ http://forum.alienslegacy.com/viewtopic.php?f=3&t=13913