Hey folks,
I was lucky enough to recently acquire one of Chef's kits and thought I would share the build pics etc with you.
The kit is 3D printed and does require some clean up and finishing as you would/should expect.
this what you get in the kit
First thing is to clean up this bit to install the switch and leds
then prepare wiring
Put the small switch in place then run the wires like this
You should end up with something like this (used hot glue to secure top )
When the little button is pressed ...
Then glue the detail piece in place
and then the little block in line with the channel
Now you can glue/drop in the perspex window sight reticule
now to prepare the catch
Assemble like this
Then glue onto the back like this
then you can glue the front comb piece on and install the elastic band
when retracted it looks like this
And then press the catch and extends like this ...
It was an easy build and looks the goods for finishing off your bucket
Cheers,