Ok guys so ive stripped my airsoft m870 down to use as a gl. Ive got as far as the trigger assembly and now im stuck.
What do i do with the safety and unloader button? And im guessing the trigger guard needs cutting off?

I did ask in the airsoft section but nobody has replyed and im guessing it would be a very similar process for all shotguns. Can anyone can help because ive come to a standstill
Thanks in advance

_________________
Happy Happy, Joy Joy

IIRC trigger guard and safety are cut off - but the front part of the guard must not be cut too short as there is a spring inside.

_________________
MSgt Matt Bradley 'Crashdown' (Formerly Mattb)
A12/TQ2.0.82145E1
CO UKCM 13th Regt. 1st Batt. 'Freebooters'
"There are very few problems that cannot be solved through a suitable application of high explosives."

don't mess with the unloader button. You will want to keep that.

Trigger guard def needs to be cut off and Crash is 100% correct, you gotta leave some space to account for the both the safety and the spring for the hammer.
I cut mine too short. It wasn't bad and I was able to recover, but it is best to avoid doing what I did.





And in case you were wondering, it IS screen accurate to have that front of the trigger large and visible. On the 10-hole hero you can see the 'nub' quite often.

Thanks for replying and clearing that up crashdown and bigbisont. I have been doing some research on others sites and the front of the trigger guard is visible on alot of builds. I have never noticed before and assumed the lot was removed. Should now be able to continue on to the next hurdle!

_________________
Happy Happy, Joy Joy