The Aliens Legacy
http://forum.alienslegacy.com/

Leftover Pulse Rifle Parts build.
http://forum.alienslegacy.com/viewtopic.php?f=3&t=10761		 Page 1 of 1
Author:  lear60man [ Sat Oct 22, 2011 7:08 am ]
Post subject:  Leftover Pulse Rifle Parts build.
After building my Live Fire PR, I had a bunch of parts leftover. So I sifted through 4 boxes of USCM gear in the workshop this morning and started working. The base is a used metal Airsoft Thompson I picked up for $80 bucks. The shrouds are first generation resin MIM. The GL is the leftover HGC. I slapped in a recoil spring for the GL so it 'racks' properly.

Upper PR is the full metal Live Fire deal. Bottom PR is the Airsoft one.
Image

I finally found the last box of parts which had aluminum shroud straps. I still need to make a proper red plastic counter window and make the little square thing behind the grip. But Im calling it done for now.Image

The HCG wall mount is full again since this girl is about a third the weight as the other one. The ground hogs in the field are running from a hail storm of plastic bb's.Image

All I need is another set of shrouds and I think I can squeak out another. Then Im done.....

Christian
Author:  PiMuRho [ Sat Oct 22, 2011 8:39 am ]
Post subject:  Re: Leftover Pulse Rifle Parts build.
Can you tell/show me where you put the spring in the HCG grenade launcher? I've got one on my PR, and I'd like to do the same.
Author:  Cooper [ Sat Oct 22, 2011 8:40 am ]
Post subject:  Re: Leftover Pulse Rifle Parts build.
UUUUUUUMMMMMMMMMMMMMMMM Live Fire ;-)
Author:  lear60man [ Sat Oct 22, 2011 4:54 pm ]
Post subject:  Re: Leftover Pulse Rifle Parts build.
PiMuRho wrote:
Can you tell/show me where you put the spring in the HCG grenade launcher? I've got one on my PR, and I'd like to do the same.



I used the recoil spring and guide pin from a broken airsoft M1A1 (its roughly 7.5 inches long). I then cut off about 1 inch. Hold the business end of the GL away from you and drill, or dremmel, a hole in the rear directly behind where the shell ejector is. Slide the spring in so it pushes the ejector forward and hold it with your thumb. Check to make sure the spring pushes it all the way forward AND it can move back far enough to 'cycle'. The full length of spring is too long and there isnt enough room to get the pump handle to move far enough back. Cut the spring too short and there will be slop in the forward and rearward movement of the pump handle. So cut the spring down in smaller segments and you will find the perfect length.

Once you have done this, slide the plastic guide pin/tube into the rear end of the spring. Now cover your hole with a piece of scrap aluminum and drill it into place with sheet metal screws. The rear end of the GL is about 3/8" thick so there is enough support for the screws.

Screws --->Aluminum plate ----> Pin ----> Spring ---> Drill hole ----> rear of GL.

I made a high tech 3D autocad rendering.....yea right.

Image
Author:  PiMuRho [ Sat Oct 22, 2011 5:52 pm ]
Post subject:  Re: Leftover Pulse Rifle Parts build.
Great info, thanks for that!
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/