| The Aliens Legacy http://forum.alienslegacy.com/ |
|
| Smartgun headset build question. http://forum.alienslegacy.com/viewtopic.php?f=3&t=10152 |
Page 1 of 1 |
| Author: | nick-a-tron [ Mon Jun 27, 2011 8:54 pm ] |
| Post subject: | Smartgun headset build question. |
Got my fantastic mars headset kit in the mail and have been dryfitting parts today. Just have one question (for now), how do these 3 parts join? Is the blue disc meant to move inside the ring or lock in place (there are 2 tabs on the ring that lock the disc in place, should I remove the tabs? Any help would be appreciated  
|
|
| Author: | Vito [ Mon Jun 27, 2011 10:15 pm ] |
| Post subject: | Re: Smartgun headset build question. |
Hey Nick, When I went to Birdie's house for him to complete my headset. You need to cut two grooves in the blue ring. My best advice as I don't want to f**k up your headset. Speak to Birdie! Wish I could remember!
|
|
| Author: | marsattack [ Sat Jul 16, 2011 12:09 am ] |
| Post subject: | Re: Smartgun headset build question. |
sorry mate !! i should have put some markings or something!! will post tonight!!! Mars |
|
| Author: | nick-a-tron [ Tue Jul 19, 2011 9:56 am ] |
| Post subject: | Re: Smartgun headset build question. |
Thanks Mars. Any help would be great
|
|
| Author: | Outcry27 [ Wed Jul 20, 2011 7:03 pm ] |
| Post subject: | Re: Smartgun headset build question. |
Detailed post incoming, gimme a sec I'll try to get some pictures for you.
|
|
| Author: | Outcry27 [ Wed Jul 20, 2011 7:39 pm ] |
| Post subject: | Re: Smartgun headset build question. |
Photos borrowed from Andy Gardner ("saintadjg") 's Photobucket gallery.   Hopefully these shots should show you how the pieces fit together. What you have to do is find a pair of long, thin screws and sink them through the existing holes in the blue vivitar disk into the Megatron scope/cannon, sandwiching the T28 "shoe" between them in the process. You can see the screw heads in the bottom picture, on the painted headset. I actually went one step further and filled that bottom part of the Megatron scope with putty, and then puttied up a small plug on the side of the Megatron piece that fits just right inside the shoe fitting. It gives the screws more to grab on to, and makes the whole joint a lot more secure. On the shoe fitting, there will most likely be a small nib or "key" inside the groove the blue disc sits in. You're going to need to remove that. I would suggest using a dremel, but if you don't have one handy, you can do it carefully with a hobby knife or a small file. Some people also put a small o-ring in there underneath the blue disc, to help keep the sight from moving on its own. Mine didn't need one, but your mileage may vary. Hope this helps! |
|
| Author: | nick-a-tron [ Thu Jul 21, 2011 12:08 am ] |
| Post subject: | Re: Smartgun headset build question. |
Fantastic! Thanks Sean thats just the info I needed Ill post photos soon of how i get on.
|
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|