Working on a UKCM project and was wondering if anyone has access to a engraver / etcher / other device that can mark brass (or other metals) plaques approx 18mm x 5mm ?
Preferably at cost but willing to pay reasonable fee.
| The Aliens Legacy http://forum.alienslegacy.com/ |
|
| Anyone got access to engraver / etcher etc http://forum.alienslegacy.com/viewtopic.php?f=11&t=13324 |
Page 1 of 1 |
| Author: | Osmotic [ Sat Jul 06, 2013 3:11 pm ] |
| Post subject: | Anyone got access to engraver / etcher etc |
Working on a UKCM project and was wondering if anyone has access to a engraver / etcher / other device that can mark brass (or other metals) plaques approx 18mm x 5mm ? Preferably at cost but willing to pay reasonable fee.
|
|
| Author: | capn thrag [ Sat Jul 06, 2013 3:55 pm ] |
| Post subject: | |
I might depending what you were needing and how much work mate |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|